← Back to InsightsTechnology

How to Fix Bad Office Wi-Fi: 3 Free Fixes to Try Before You Buy

· 3 min read

A wireless access point mounted on an office ceiling

To fix bad office Wi-Fi, move the router before you buy anything: put it in the middle of the space, get it off the floor and keep it away from interference. The usual reaction to one bar of signal is a faster plan or a bigger router. Hold off. Often the internet and the hardware are fine, and the problem is where the box sits. Here are three fixes that cost nothing.

First, check whether it’s the Wi-Fi

Plug a laptop into the router with a network cable and repeat whatever was slow. If it’s fast on the cable and slow on Wi-Fi, the signal is the problem and the fixes below apply. If it’s slow on the cable too, the cause is the connection or the network. Our posts on how bandwidth works and fixing a slow network cover that side.

1. Put the router in the middle

Think of the router as a lightbulb. Put it in a far corner and the rest of the building stays dim. Wi-Fi radiates in every direction, so a router against an outside wall sends half its signal into the parking lot. Move it toward the center of the space and every laptop, tablet and printer has less distance to cover.

2. Get it off the floor

A common mistake is a router on the carpet, behind a filing cabinet and a knot of power strips. The signal spreads outward and down, so a router at floor level sends much of it into the foundation. Concrete and metal floor supports block it before it reaches a desk. Raise it to eye level or higher. Mount it on a wall or set it on top of a bookshelf.

3. Keep it away from interference

Three things wreck a wireless signal: metal, water and competing electronics.

  • Microwaves run on the same 2.4 GHz band as a lot of older Wi-Fi.
  • Water absorbs signal. A fish tank or heavy plumbing in a wall will choke it.
  • Metal reflects it. A fire door or a row of filing cabinets creates a dead zone behind it.

Walk through the office. If the router sits beside the breakroom microwave or behind a metal door, you’ve found the dead zone.

When placement isn’t enough

If you’ve moved the router and still hit dead zones, the answer is usually several wireless access points or a mesh system. They cover the whole office with one managed network, so the connection holds when someone walks into the conference room. Old equipment can also be the limit. Our post on network gear that’s due for an upgrade covers when to replace it.

While you’re at it, put visitors on a separate guest network.

Networks, including the devices that sit on them, are part of what we cover in Managed IT Services.

If you’ve tried all three and the signal still drops, book a 30-minute call. We’ll ask about your space, where the equipment sits and where the signal fails, and tell you what we’d change.

Want this handled for your business? Book a 30-minute call and we'll give you a straight read on where you stand.

Book a call

FAQs

Why is my office Wi-Fi so weak?

The usual cause is placement. A router in a corner, on the floor or next to metal, water or a microwave loses much of its signal before it reaches your desk. Move it to the middle of the space, raise it and clear what's around it before you buy anything.

Where is the best place to put a Wi-Fi router in an office?

Near the center of the area it serves, at eye level or higher, in the open. Keep it away from outside walls, metal cabinets, fire doors, microwaves and large amounts of water such as an aquarium.

Will a faster internet plan fix weak Wi-Fi?

No. A faster plan raises the speed coming into the building. It doesn't carry the signal any farther inside it. Plug a laptop into the router with a cable. If it's fast on the cable and slow on Wi-Fi, the problem is coverage.

What blocks a Wi-Fi signal?

Metal, water and concrete block or absorb it, and other electronics compete with it. Filing cabinets, fire doors, plumbing in a wall, a fish tank and a breakroom microwave are common culprits in an office.

When does an office need access points or a mesh system?

When one router can't cover the space even after you've placed it well. Larger offices, more than one floor and thick walls call for several access points managed as one network, so devices stay connected as people move around.

Talk it through with us

Book a 30-minute exploratory call. We'll tell you where your environment stands and what we'd fix first. If we're not the right fit, we'll say so.

Book a call

Practical IT tips, by email

Short, practical IT and security tips for business owners, written by the team that runs our clients' IT.

Unsubscribe anytime.